Reverse Polarity Protection

by malabdalicircuit design

eries Diode – By far the cheapest and easiest to install is a diode in series with the positive power lead. Anode toward the power supply and Cathode (banded end) going to the radio. For a few pennies a 1N400x series diode will handle many QRP rigs up to 1A and a 1N540x series will work up to 3A. Although simple and cheap it comes at a cost. The diode will drop about 0.6-0.9V which could result in lower transmit power and if the equipment uses voltage regulators this lower voltage may be under the regulator level.

RPP-Diode

Bridge Rectifier – The most foolproof for reverse polarity protection. For about a dollar or two, the bridge will correct the polarity no matter how you connect the power supply. With a bridge there are always 2 diodes conducting which can result in greater losses of round .8-1.5V.   This works good only when a single power supply is used with a single radio but should be avoided when multiple pieces of equipment are connected together via the grounds.

RPP-Bridge-Fixed

Fuse with crowbar diode – With most protection circuits there is usually some form of loss in the process, as seen in the diode examples above. However, the fuse with crowbar diode has no voltage drop loss. The crowbar works by putting a diode across the voltage lines with the Cathode toward the positive side. This in effect leaves the path through the diode open unless the polarity is reversed. When that happens the diode now becomes an almost short circuit causing the fuse to blow. The cost of course if that a hefty diode needs to be used to handle the large current flow until the fuse opens up, not to mention a new fuse each time it’s tested.

RPP-Crowbar

MOSFET1 – Not only can MOFSET’s do a great job at switching, a P-channel MOSFET does an excellent job of reverse polarity protection. Depending on your needs the cost is from a few pennies to a dollar or two. Under normal circumstances the MOSFET is turned on with a small voltage drop across it, typically fractions less than the diode example above. When the polarity is reversed the MOSFET is forced off and creates an open circuit. See the sidebar on MOSFET selection for more information in selecting a P-channel MOSFET.

RPP-MOSFET

MOSFET RPP Rules:

  1. VDS – Voltage Drain to Source – must be greater than the power supply voltage.
  2. RDS(on) – Resistance of the Drain to Source when the MOSFET is turned on. This must be as low as possible. Usually the lower the Rds(on) the more expensive.
  3. Vgss – Voltage from Gate to Source – The maximum voltage allowed from Gate to Source. This should also be greater than the power supply voltage. Many MOSFET’s will have a lower Vgss. In these cases the addition of a simple zener diode and resistor are required as follows:
    1. Resistor is not critical, almost any value between 10K and 100K is good.
    2. Zener voltage must be less than the MOSFET Vgss. Additionally it must be greater than the MOSFET Vgs(th) – Threshold Voltage from Gate to Source – This is the minimum voltage required to fully turn on the MOSFET.
  4. There is a small capacitor in the Drain to Gate circuitry. This capacitor is optional but recommended and only used for static discharge protection.2
RPP-MOSFET-low